Samson DOUBLE BRAID Class II End-for-End Splice Modified Manual do Utilizador descarregar pdf (Página 3)

PAGE 3 OF 4

SamsonRope.com | Email [email protected] | Tel +1.360.384.4669

Double Braid Class II End-for-End Splice Modiﬁed for Turbo-37

SAMSON SPLICING INSTRUCTIONS

Figure F

Figure G

Figure I

Figure J

Figure H

step

REPEAT PROCEDURE

JOINING SUB-ROPES 2

SPLICING CENTER SUB-ROPES

MAKING ADDITIONAL TUCKS

Repeat this procedure, now tucking the left-hand sub-rope 1 into

the right-hand sub-rope 1 (Fig. F). Draw the left-hand sub-rope all

the way through to close up the crossover (Fig. G). Place a wrap

or two of tape around the crossover point.

Repeat Steps 9 –11

with sub-ropes 2

(shown in Fig. K) and

then sub-ropes 3.

Now select the center sub-ropes and splice them together,

again following the procedure outlined in Steps 9 –11.

Make an additional 14 tucks in each direction. A tuck

consists of passing the tail over 1 strand, and under

1 strand, always against the lay. When pulling the tail

through, pull perpendicular to the direction the rope

is lying in, and take care not to over tighten the tuck,

this will cause unnecessary distortion. Fig. G shows

normal appearance after 1 tuck each direction. As

the splice progresses, the tail should gradually spiral

around the standing part. To accomplish this, it is

necessary to pull the tail underneath the standing part

on every 3rd or 4th tuck (Fig. H).

Complete 15 tucks with full volume tail, then remove

1 strand from tail and complete 3 tucks with the

remaining 2 strands (Fig. I). Now remove 1 strand

and complete 3 tucks with the remaining 1 strand

(Fig. J). Tape the tails to the rope.

11A

11B

step

Pairing of bottom 3 sub-ropes (sub-ropes numbered 1 will be

spliced together, numbered 2 will be spliced together, etc.)

Note: After splicing bottom 3 and center 1, top 3 will be paired likewise.

Top 3

Center

Bottom 3

Figure K

step

SPLICING TOP SUB-ROPES

Arrange the top 3 sub-ropes as in Fig. 3. Starting with sub-

ropes 1, splice all of the top sub-ropes as in Steps 9 –11.

1 2 3 4

Comentários a estes Manuais

Sem comentários

Samson DOUBLE BRAID Class II End-for-End Splice Modified Manual do Utilizador Página 3

Comentários a estes Manuais

Manuais e produtos relacionados com Ferramentas Samson DOUBLE BRAID Class II End-for-End Splice Modified