Samson MISCELLANEOUS Smooth Ice/Flavored Ice Cover Instal Manual do Utilizador

Consulte online ou descarregue Manual do Utilizador para Ferramentas Samson MISCELLANEOUS Smooth Ice/Flavored Ice Cover Instal. Samson MISCELLANEOUS Smooth Ice/Flavored Ice Cover Installation User Manual Manual do Utilizador

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 3
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 0
PAGE 1 OF 3
SamsonRope.com | Email [email protected] | Tel +1.360.384.4669
Smooth ICE/Flavored ICE Cover Installation
SAMSON SPLICING INSTRUCTIONS
MARKING AND KNOTTING
1
step
2
step
Lay out rope to be covered and from the end to be covered, measure off distance to be covered and make
Mark 1 on the rope. From Mark 1, measure off a distance of 15 inches and make Mark 2 on the rope.
Lay out Ice cover below rope to be covered and allow 15% more cover length than rope to be covered from Mark
1 to the end of the rope. Then make Mark 1 on the cover using Mark 1 on the rope as a guide. Next make Mark 2
and Mark 3 on the cover by measuring off 6 inches for each mark.
Feed rope into cover and milk cover
over rope until Mark 1 of cover and
Mark 1 of rope are matched. Then
lock stitch the cover to the rope from
Mark 1 back for 3 complete passes.
3
step
Tape and cut the Ice cover at Mark 3. Then extract the internal feed line from the cover at Mark 1. Attach feed line
to rope end to be covered by passing the feed line through the rope braid and forming a loop knot. Be careful not
to pull the feed line into the cover on the other end.
Attach feed line from other end of cover
to a xed point for assistance in burying
the rope into the cover.
4
step
5
step
Ice cover plus 15% extra length
Mark 1
Mark 2
Mark 3
Section of rope to be covered
Mark 1 Mark 2
15"
Attached feed line to rope with loop
knot. Tape for smooth transition
between feed line and rope
Extract feed line at Mark 1 on cover
Mark 1
Tie off 1 end of feeder core
Lock stitch cover to rope
pusher
Insert fid at Mark 1 on rope and exit at Mark 2
Cover, insert in fid.
6
step
Insert a splicing d, d should be sized to rope diameter, with the cover into the rope as
close to the lock-stitch as possible. Continue pushing the d through the center of the
rope and extract the d and cover at Mark 2 on the rope.
Vista de página 0
1 2 3

Resumo do Conteúdo

Página 1 - MARKING AND KNOTTING

PAGE 1 OF 3SamsonRope.com | Email [email protected] | Tel +1.360.384.4669Smooth ICE/Flavored ICE Cover InstallationSAMSON SPLICING INSTRUCTI

Página 2

PAGE 2 OF 3SamsonRope.com | Email [email protected] | Tel +1.360.384.4669Smooth ICE/Flavored ICE Cover InstallationSAMSON SPLICING INSTRUCTI

Página 3 - Choosing twines for whipping:

© 2012 Samson Rope Technologies, Inc. All rights reserved. S/WD #108294 7/2012PAGE 3 OF 3SamsonRope.com | Email [email protected] | Tel +1

Comentários a estes Manuais

Sem comentários