Samson VX2510 Manual do Utilizador descarregar pdf (Página 6)

Guided Tour - VX2510 & VX2515 Front Panel

1. Passive Input jack - If your bass guitar has passive circuitry, connect it

to the Model 2500 here. This standard, 1/4” unbalanced jack provides a high

impedance (100 k Ohms) input sensitivity of 20 millivolts.

2. Active Input jack - If your bass guitar has active circuitry,* connect it to

the Model 2500 here. This standard, 1/4” unbalanced jack provides a high

impedance (100 k Ohms) input sensitivity of 60 millivolts.

3. Pre-Amp A (Tube Emulation) control - This determines the amount of

preamplification being provided by special circuitry which delivers the sound

of a classic tube amplifier. Note that when both Pre-Amp knobs are used at

equal settings, the amplifier will be twice as loud as when only one is used.

Avoid setting both Pre-Amp knobs on maximum (“10”), since the result will

almost always be undesirable distortion.

4. Pre-Amp B (Solid State) control - This determines the amount of pream-

plification being provided by special circuitry which delivers the sound of a

solid state amplifier. Note that when both Pre-Amp knobs are used at equal

settings, the amplifier will be twice as loud as when only one is used. Avoid

setting both Pre-Amp knobs on maximum (“10”), since the result will almost

always be undesirable distortion.

* Bass guitars that have active circuitry normally require a battery for the cir-

cuitry to be functional.

HA2500



  

 





1 2 3 4 5 6 7 8 9 10 11 ... 19 20

Sem comentários

Samson VX2510 Manual do Utilizador Página 6